Peak Level Memory & Test Buttons on Your Carbon Monoxide Alarm

How to Use the Test Button

Any time you push the Test/Reset button, the alarm will go through a series of test numbers that are programmed into the unit to test the internal diagnostics. This will start with an 888 reading, then display numbers usually in the 200 range, then back to 888, and lastly to zero. These are not actual readings, so you don't have to be alarmed or take action.

What Is Peak Level?

The Peak Level reading is just a memory. At one point, the unit was exposed to something that caused the reading. It could have been a substance that was sprayed too close to the unit, paint fumes, or actual carbon monoxide that caused the reading. The peak level will show the highest reading the unit has had since it was reset.

How to Reset the Peak Level Memory

To reset the peak level memory, push the Peak Level button and hold it down while you press and hold the Test/Reset button for 2 seconds, then release them at the same time.

Monitoring After Reset

After this, monitor the unit for a few days to determine if this is a recurring problem or if it was an old reading. If you don't get a reading, then you know it could have just been a random reading and you have no other event taking place. If a reading does come back, reset the peak level again and start watching it every one to two hours to try to narrow down when the reading is happening and be aware of what's going on around you (heat coming on or off, cleaning, etc.) to determine the source of the reading.

Need Further Assistance?

If you have any questions or need further assistance, please don't hesitate to contact our customer care team.

They are available to help you with any concerns or inquiries you may have. Reach out to us for support, and we'll be happy to assist you!